Browsing by Subject "Anbautechnik"

Now showing 1 - 3 of 3
  • Thumbnail Image
    Publication
    Developing cropping systems for the ancient grain chia (Salvia hispanica L.) in two contrasting environments in Egypt and Germany
    (2020) Mack, Laura; Graeff-Hönninger, Simone
    Chia (Salvia hispanica L.) seeds have been revived as functional “superfood” for human nourishment especially for vegan and vegetarian diets and are becoming increasingly widespread and present in new food products in Europe. The seeds are beneficial because of being gluten-free, containing antioxidants and a high concentration of α-linolenic acid, and having a high content of dietary fiber and high-quality protein. Chia is originally adapted to short-day conditions and grows naturally in tropical and subtropical environments. Nevertheless, it can survive under water stress and could, therefore, be cultivated in arid regions. Egypt has been classified as a water-scarce state. Due to its drought tolerance, chia might contribute to saving the scarce source “water” in Egypt and offer the chance to export these high value seeds, generating foreign exchange for reimporting e.g. wheat characterized by a higher water demand. Worldwide, the biggest problems and key challenges under climate change (CC) are water and food security in arid and semiarid regions. In the future, CC and water scarcity will significantly threaten agriculture and sustainable development. A rising population requires on the one hand an increase in food grain production, but also a change toward environmentally sound sustainable agriculture. Chia has been suggested as a favorably economic alternative for common field crops sustaining diversification and stabilization of the local agricultural economy. However, broad experience in growing chia in new environments is missing. The agronomic management has not been improved from formerly small-scale production systems. Most of the previous studies focused on seed characteristics. Information on fertilization, plant protection, and improved varieties is scarce, which are reasons for its low productivity in the countries of origin. Field experiments were conducted at the experimental station “Ihinger Hof” of the University of Hohenheim in southwestern Germany from 2015 to 2017 and in Egypt during the cropping season 2015 to 2016 at SEKEM’s experimental station located 50 km Northeast of Cairo. The present doctoral thesis was based on a project embedded in the graduate school Water-People-Agriculture (WPA) at the University of Hohenheim funded by the Anton-&-Petra-Ehrmann foundation that focuses on key water issues and water related challenges of todays society. On a final note, the main results of this thesis provide further information and expanded knowledge on chia cultivation in two contrasting environments (including a desert region) out of its center of origin. Overall, the current doctoral thesis presents a combined approach of experimental field research and crop modeling to support the optimization of farming practices of chia in new environments. A universal and nondestructive LA estimation model for chia was developed. Further, the CROPGRO model was adapted for chia to provide a preliminary model for a realistic simulation of crop growth variables. The approaches presented in this thesis may contribute to testing new environments for chia cultivation and to improving its production. Moreover, this study helped to develop further general model source codes to simulate the growth of tiny seeds. The adaptation to other Salvias should be much easier with this developed model. Future research requirements and issues requiring model improvement such as N-response and the development of code relationships that can simulate parameters of seed quality could improve the plant growth model for chia.
  • Thumbnail Image
    Publication
    Integrated weed management in a pesticide free area
    (2023) Saile, Marcus; Gerhards, Roland
    Weed control is a challenging task for farmers in highly specialized crop production systems. The competition of weeds for light, nutrients and water causes significant yield losses. Chemical weed control is still the standard method in European cropping systems. Due to their high selectivity and efficacy against a wide range of weed species, herbicides provide the most efficient weed control in most crops. However, negative impact of herbicides on the environment, loss of biodiversity, possible risks to consumers due to residues in food chain and the increase and spread of herbicide-resistant species force farmers to reduce herbicide use and call for alternative weed control methods. Mechanical weed control methods including hoeing and harrowing represent the most promising alternative direct weed control methods. Weed control costs for mechanical methods are still higher than for herbicides and weed control efficacy is often lower with less than 80 % compared to around 95 % for herbicides. The efficacy of mechanical weed control is dependent on external factors such as soil water content, soil texture, and weed species diversity in the particular field. Herbicides can therefore not be replaced by a single mechanical weed control method. It needs an Integrated Weed Management (IWM) strategy including preventive and direct methods of weed suppression. In this study, IWM were investigated for typical arable farming systems in Southwestern Germany. Studies for this thesis were conducted from 2017 to 2022. The objectives of the thesis were to combine preventive and curative methods of weed control in diverse cropping systems and to improve mechanical weed control methods by precision farming technologies. The results of the thesis have been published in five papers. The first article addressed the effects of preventive weed control by stubble tillage, cover cropping, and the use of glyphosate treatments against Alopecurus myosuroides and volunteer cereals. In two field trials at two sites, cover crop mixtures achieved equal weed control efficacy of up to 100 % as the dual glyphosate treatment. Stubble tillage practices resulted in lower control but caused the highest energy consumption. The second article focused on the effect of two seeding dates (early-, delayed-sowing) and different herbicide strategies on A. myosuroides control on winter cereals. This study was conducted over three years at three locations. Delayed sowing reduced weed emergence by 30-40 %. Delayed sowing in combination with the pre-emergence herbicide cinmethylin provided equal weed control efficacy as a combination of pre-emergence and post-emergence herbicides. The third article focused on the control of A. myosuroides including the combination of integrated stubble management and various application rates of the pre-emergence herbicide cinmethylin. In four field trials over a two-year period, the pre-emergence herbicide cinmethylin was applied at two application rates at two sites. Control success of up to 100 % was achieved through the combination of inversion tillage, false-seedbed preparation and the reduced rate of cinmethylin. The results also showed a high variation of the effect of preventive measures. The fourth article deals with IWM in spring oats and winter wheat. Field experiments were conducted at two locations over two years in five field trials. Chemical weed control was combined with sensor-based mechanical weed control. Data showed that sensor-based mechanical weed control (hoeing and harrowing) in the field trials achieved equal weed control efficacy of up to 100 %. However, highest grain yields were recorded for the combination of pre-emergence herbicide and post-emergence mechanical weed control. The last article dealt with a new cultivation system without chemical synthetic pesticides but with mineral fertilizers (MECS). The hypothesis was that MECS would increase the competitiveness of the crop on the weeds and generate higher yield benefit compared to the organic cultivation system. Field trials were conducted at four sites over two years. Three different cropping systems, an organic cropping system managed according to organic farming guidelines, a conventional cropping system and a MECS, were compared in a 5-year crop rotation. After two years of studies, no clear conclusion can be made how MECS affects the interaction of crops and weeds. Weed control efficacy in MECS was lower than organic farming. The increase in weed pressure in MECS will cause problems in the subsequent crops. Yields were significantly higher in MECS compared to the organic system and only slightly lower than in the conventional system. It can be concluded from these studies that IWM in combinations with precision farming technologies for mechanical weeding can replace herbicides. However, weed control costs were higher with non-chemical weed control methods.
  • Thumbnail Image
    Publication
    The bioeconomy potential of hemp (Cannabis sativa L.) : challenges of new genotypes and cultivation systems to meet the rising demand for phytocannabinoids
    (2021) Burgel, Lisa; Graeff-Hönninger, Simone
    Cannabis sativa L. as a prime example of a multifunctional crop is excellently suited for recycling management due to its versatility and the usability of the whole plant. Cannabis currently experiences a boom due to its rich phytochemical repertoire, its fibres and valuable oil required in numerous products, and its unique agricultural properties. The medical benefits of C. sativa, based on the phytocannabinoids available in flowers and leaves, are the main focus of attention worldwide. Innovative markets in the food, cosmetics and pharma industry are growing fast, with a focus on cannabidiol (CBD), which is the leading cannabinoid of the cannabis plant. Basically, it is important to differentiate between industrial hemp genotypes and phytocannabinoid-rich (PCR) cannabis genotypes. Industrial hemp meet the 0.2% THC limit mandated by the EU legislation, and therefore, can be legally cultivated by farmers on a field scale. PCR genotypes contain high amounts of non-psychoactive cannabinoids such as CBD and cannabigerol (CBG) in the range of 10 – 30% while their THC content is also below 0.2%. These genotypes are currently being bred but are still barely available on the market. Cannabinoid extraction from industrial hemp cultivated on a field scale could provide a decisive advantage as the harvested biomass quantities could be significantly increased through better land use and cost management, compared to an indoor system. The multi-functionality of the industrial hemp can provide added economic value. Therefore, existing cultivation systems for fibre and oilseed production have to be modified as the harvesting time and harvested organ are expected to differ greatly from those of the present systems. In order to achieve this, publication I dealt with the objective, to determine the yield potential of different EU-registered hemp genotypes with regard to inflorescence and biomass yield as well as cannabinoid content, depending on genotype, growth stage and biomass fraction in an outdoor cultivation system. The cultivation of seven industrial hemp genotypes (Finola, Fédora17, Ferimon, Félina32, Futura75, USO 31 and Santhica27) was carried out in a two-year field experiment. Sampling of leaves and inflorescence, took place at four specific growth stages: vegetative leaf stage, bud stage, full-flowering stage, and seed maturity stage. Dry matter was recorded, and cannabinoids were analysed. The results indicated that the content of cannabinoids highly depended on the genotype and the growth stage. Thus, biomass and inflorescence yields must be considered for an optimized harvest result. Genotype Santhica27 indicated the highest contents of CBG/A. Further, it was found that genotypes such as Futura75, Fédora17, Félina32, Ferimon, Finola and Santhica27, which were highlighted to have a higher CBD/A or CBG/A content compared to other evaluated genotypes, reached the highest yields of threshing residues after seed maturity, and thus a higher CBD/A and CBG/A yield per area. In conclusion, harvesting after seed maturity seems to be economically beneficial. These findings make selected industrial hemp genotypes excellent candidates for multipurpose cropping. Additionally, the thesis aimed at further standardization of PCR genotypes in indoor cultivation systems. Due to the prescribed requirement of high-quality medical cannabis material, indoor cultivation is in focus as under the system all production parameters can be standardized. The production of cannabinoids under indoor conditions is expensive due to processing costs and regulatory limitations, thus there is an increasing interest in using the available space requirements efficiently. Publication II evaluated the adaptation of the plant architecture, through the targeted use of synthetic phytohormones, aiming for a small and compact plant morphology for various indoor systems. The objective was, to test the impact of exogenously applied plant growth regulators (PGRs), such as NAA, BAP and a mixture (NAA/BAP-mix) of both on the plant architecture of different PCR genotypes. Therefore, genotypes were treated with synthetic phytohormones in various concentrations in a greenhouse experiment. Furthermore, the differences in leaf and flower yields resulting from morphological changes in these genotypes and their CBD/A content was investigated. A genotype-specific impact of applied PGRs on the plant architecture was determined. NAA led to more compact plants with a consistently high floral yield for genotype KANADA, whereas CBD/A content was not affected. Genotypes 0.2x and FED showed reduced floral yields due to the PGRs applications. Publication III dealt with the evaluation of the growth performance of PCR genotypes grown in different substrate compositions substituted with peat alternatives in an indoor cultivation system. The impacts of the following substrate compositions: peat-mix growth media (PM); peat-mix substituted with 30% of green fibres (G30) consisting of coniferous wood and wood chips from pine and spruce wood growth media, and coco coir fibres (CC), on growth performance, biomass and flower yields, biomass nitrogen (N) content as well as CBD/A contents were tested. The results showed that the different substrates had significant impacts on the growth, biomass and floral yields, root development and N tissue content of the tested genotypes. A genotype-specific reaction on floral yield was investigated. While genotype KANADA had the highest floral yields when grown in PM, 0.2x showed no significant differences, with higher floral yields grown in G30 and CC. For both genotypes, no limiting effect on CBD/A content was enacted. It can be concluded, that organic peat alternatives such as green fibres, partly replacing peat in standard growing media, offers a genotype-specific option.