Browsing by Subject "Particle size"

Now showing 1 - 3 of 3
  • Thumbnail Image
    Publication
    Homogenization improves foaming properties of insoluble pea proteins
    (2022) Moll, Pascal; Salminen, Hanna; Griesshaber, Elena; Schmitt, Christophe; Weiss, Jochen
    Foams are essential in many food applications and require surface-active ingredients such as proteins for formation and stabilization. We investigated the influence of high-pressure homogenization on foaming properties of insoluble pea protein dispersions (5% w/w) at pH 3 and 5. Unhomogenized insoluble pea protein dispersions did not foam at either pH 3 or 5, as they consisted of large insoluble pea protein aggregates with limited surface activity. At pH 3, the homogenized pea protein dispersions generated foams due to higher protein solubility and surface activity through disruption of large protein aggregates into smaller particles. The foam stability decreased with increasing homogenization pressure and number of cycles due to a reduction in continuous phase viscosity. At pH 5, the insoluble pea proteins foamed when the homogenization resulted in formation of aggregates made of smaller protein entities, which was the case for homogenization ≥ 100 MPa and three cycles. In general, the foam capacity (amount of formed foam) was higher at pH 3 due to improved protein solubility and surface activity that facilitated incorporation of air, while the foam stability (resistance against foam collapse) was better at pH 5 because of the presence of larger protein aggregates that formed thicker and more viscous films around the air bubbles benefitting retention of gas bubbles. Overall, homogenization improved the foaming properties of insoluble pea proteins at pH 3 and 5.
  • Thumbnail Image
    Publication
    Hydrostatic high pressure treatment of casein to generate defined particle and gel structures
    (2006) Merel-Rausch, Eva; Hinrichs, Jörg
    The focus of the work was to study the influence of pressure treatment conditions on pressure-induced casein structures in detail. The influence of process parameters like pressure build-up, pressure level, holding time and release rate but also temperature, ionic strength and casein concentration were determined. This work showed that the structure formation of casein under high pressure treatment depends on numerous factors. Sols but also gels can be formed and could be used for different applications particularly with the choice of the release rate and the milieu conditions, even if pressure conditions and casein concentration are kept constant.
  • Thumbnail Image
    Publication
    Investigations on the effects of forage source and feed particle size on ruminal fermentation and microbial protein synthesis in vitro
    (2012) Hildebrand, Bastian; Rodehutscord, Markus
    The synthesis of microbial protein in the rumen has a major impact on protein- and amino acid supply in ruminants. The amount and amino acid composition of the protein that enters the small intestine primarily depends on diet formulation. In the present studies the effects of maize silage (MS) and grass silage (GS) on ruminal fermentation and microbial protein synthesis were investigated, considering methodical aspects of in vitro studies, particularly grinding of feed samples. In the first experimental series five mixed diets with different proportions of MS and GS (100:0, 79:21, 52:48, 24:76 and 0:100) and a constant proportion of soybean meal (11%) were used. The content of crude protein (CP) and fibre fractions increased, whereas the content of organic matter (OM) and starch decreased with increasing proportion of GS in the diet. It was hypothesised that a combination of MS and GS can benefit microbial growth and thus fermentation of nutrient fractions to a higher extent than using only one forage source separately. It was also to be investigated how changes in diet composition affect the amino acid profile of microbial protein. A well standardised semi-continuous rumen simulation technique (RUSITEC) was used, which is a commonly accepted experimental model in investigations on ruminal fermentation. Changes in fermentation characteristics, as a result of changing the MS-to-GS ratio, were tested for linear and quadratic effects in order to identify possible associative effects. Prior to the in vitro incubation, feedstuffs were dried and ground. It was aimed to investigate in which way fermentation in the RUSITEC system is influenced by mean feed particle size. Therefore two milling screen sizes (MSS; 1 vs. 4 mm) were used in all diets and results on fermentation characteristic were tested for possible interactions of forage source and MSS. One incubation period lasted for 13 days (6 days adaption period, 7 days sampling period), and each treatment was tested in at least three replicates. Ruminal digesta, obtained from rumen-fistulated wether sheep, was used as the inoculum for starting the incubation. Diets were fed once daily to the RUSITEC system, and nylon feed bags remained for 48 h inside the fermentation vessel. A buffer solution, containing 15NH4Cl, was infused continuously into the vessel and the respective effluent was analysed for short chain fatty acids (SCFA) and NH3-N. Solid- and liquid- associated microbial fractions were isolated from the feed residues, the liquid inside the vessel and the effluent by differential centrifugation. The flow of microbial CP was quantified on the basis of N and 15N balances. The feed residues were analysed for crude nutrients and detergent fibre fractions and the respective degradation rates were calculated. OS and CP in the feed residues were corrected for the contribution of solid-associated microbes. The degradation of OM and fibre fractions, as well as amounts of NH3-N increased linearly with stepwise replacement of MS by GS. Degradation of CP was unaffected by diet composition, as well as total SCFA production. The degradation of OM and CP was higher in coarse milled (4 mm-MSS) than in fine milled (1 mm-MSS) treatments, accompanied by higher amounts of NH3-N and total SCFA. An improvement of growth conditions for some microbial groups, e.g. anaerobe fungi, was discussed. The amount of microbial CP increased linearly by the stepwise replacement of MS by GS, and was higher at 4 mm-MSS than at 1 mm-MSS. The amount of available N was assumed to advance microbial growth in the RUSITEC system. Efficiency of microbial CP synthesis was improved from 29 to 43 mg microbial N per g degraded OM by increasing the proportion of GS in the diet, but was unaffected by MSS. The N content and the profiles of amino acids of the three microbial fractions, as well as the ratio of solid- to liquid-associated microbes were affected by diet composition and MSS. Interactions of forage source and MSS were rare. However, the results indicated interactions between dietary factors and origin of microbial isolate on characteristics of microbial protein synthesis. In order to provide additional information on the nutritional value, the mixed diets were evaluated by two further methods. The total tract digestibility of crude nutrients was determined in wether sheep. The content of metabolisable energy was similar between diets and averaged 11.5 MJ per kg dry matter. The in vitro gas production was measured within 93 h by using a modified Hohenheim gas production test, providing information on kinetics and extent of ruminal fermentation. Cumulative gas production decreased with increasing proportion of GS in the diet. A negative effect of coarse milling on fermentation in the Hohenheim gas production test was confirmed. Across all diets gas production was delayed at 4 mm-MSS compared to 1 mm-MSS. The results from both approaches supported the findings of the RUSITEC study that a stepwise replacement of MS by GS led to a linear response in degradation of nutrients. As indicated by the gas production data, positive associative effects might only occur in the first hours after starting an incubation. When mixed diets are used effects cannot be clearly related to individual diet ingredients. Moreover, in the mixed diets interactions between soybean meal inclusion and forage source or feed particle size cannot be excluded. Therefore pure silages were incubated separately in the RUSITEC system in the second experimental series and three milling screens of different size were used (1, 4 and 9 mm). In accordance with the first experimental series, degradation of OM, fibre fractions and non-structural carbohydrates, production of NH3-N, as well as microbial CP flow and efficiency of microbial CP synthesis were higher in GS than in MS. A higher degradation of CP was found for MS than for GS, indicating interactions between forage source and soybean meal inclusion. An increase in MSS from 1 mm to 9 mm led to an improvement in the degradation of OM, CP and non-structural carbohydrates, particularly of starch in MS, as well as in the microbial CP flow for both silages. But the efficiency of microbial CP synthesis and microbial amino acid profile were less affected by MSS. In the second experimental series additionally the effect of available N on fermentation of MS was investigated. The supplementation of urea-N improved the degradation of non-structural carbohydrates, especially starch, but not that of fibre fractions in MS. The efficiency of microbial CP synthesis was increased from 26 to 35 mg microbial N per g degraded OM by urea-N supplementation to MS. The way of urea administration, either supplied together with the feed once daily or infused continuously by buffer solution, had only marginal effects on fermentation characteristics. It was concluded that microbial growth is improved by degradation of OM from GS compared to MS and by an increasing availability of N in the RUSITEC system. Meaningful associative effects of mixtures of MS and GS on ruminal fermentation characteristics are not likely to occur. However, transferability of results to other batches of MS and GS is limited, as high variations in chemical composition are known for both types of silage. Fermentation of MS- and GS-based diets in the RUSITEC system benefits more by coarse milling at MSS up to 9 mm than by fine milling at 1 mm-MSS. Consequently, variations in MSS and feed particle size distribution have to be taken into account when evaluating feeds by rumen simulation systems. The changes in composition and contribution of microbial fractions give indications to a shift in the microbial community as a result of variation of silage type and feed particle size, but further research on this aspect is needed. Moreover, the present results stated that the origin of the microbial samples is very important for measurements on microbial protein synthesis.